Eizo FLEXSCAN MX190 Manual do Utilizador descarregar pdf (Página 18)

RadiCS

Chapter 2 RadiCS Setup

English

6. To correlate data during the monitor measurement, click [Correlation].

Tips

• When RadiCS detects two or more monitors to which Clip-On Swing Sensor is

connected, the [Correlation] check box appears. When the check box is enabled,

multiple monitors can be correlated simultaneously (the check box does not appear

when only one monitor is detected).

7. Attach an EIZO sensor (UX1) in the center of the measurement window, and

click [Proceed].

Correlation starts. Operation takes approximately 13 minutes for a monochrome monitor,

or approximately 3 minutes for a color monitor. (Clip-On Swing Sensor

)

NOTE

•

Only EIZO sensor (UX1) can be used for multicorrelation.

8. When correlation is ﬁnished, click [Finish].

When the Swing Sensor setup is ﬁnished, the Swing Sensor is registered as “Clip-On Swing

Sensor” or “Built-In Swing Sensor” on the monitor screen.

9. When managing multiple monitors, perform the same setup for all the monitors.

10. The monitor setup wizard is completed.

Tips

• When RadiCS starts up initially, monitor quality control standards, calibration settings,

schedule settings, and registration information are all set automatically.

• T

o change settings, start up task setup wizard by clicking [Conﬁguration] - [Wizard] in

the advanced mode, or select each separate conﬁguration menu.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 98 99

Sem comentários

Eizo FLEXSCAN MX190 Manual do Utilizador Página 18