Eizo FLEXSCAN MX190 Manual do Utilizador descarregar pdf (Página 17)

RadiCS

Chapter 2 RadiCS Setup

English

Monitor Information Window

Monitor Type Select the monitor type from Color LCD, Monochrome LCD,

Color CRT, or Monochrome CRT.

Select Monitor Displays the “Select Monitor” dialogue. When you select a

monitor from the list, its information is automatically entered.

Manufacturer/

Model Name/

Serial Number (S/N)

Enter the manufacturer, model name, and serial number (S/N).

Asset Number Enter the asset management number.

Installed on Select the date of introduction.

CAL Switch

Mode1 to Mode3

If only a single mode can be calibrated, entries are only

available for Mode1. If several modes can be calibrated,

entries are available for Mode1 to Mode3. The number of

modes depends on the model of the RadiForce monitor.

To manage a mode with RadiCS LE software, enable the

“Control” check box.

Note

・

Only Mode1 can be set when GS521-ST is used.

Use Select from CT, DR, DSA, MMG, MR, NM, PACS or US. You

can enter any strings in the “Use (Comment)” ﬁeld.

Back Returns to the monitor type judgment dialogue.

Next Goes to the monitor setup wizard of the next monitor when

setting Wide View or Mirroring.

4. When using a Clip-On Swing Sensor, click [Next >] and make the settings.

When not using a Clip-On Swing Sensor, proceed to step 9.

5. Install the Clip-On Swing Sensor by aligning it to the center of the displayed

pattern. Click [Proceed] to have the software detect the monitor with the Clip-

On Swing Sensor.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 98 99

Sem comentários

Eizo FLEXSCAN MX190 Manual do Utilizador Página 17