ENGLISHENGLISH
10 1. INTRODUCTION1-3. Controls & ConnectorsFront(1) ScreenManager™(2) AUTO Adjustment button(3) Control Buttons(4) Enter Button(5) Power Switch(6
2. CABLE CONNECTION 11ENGLISH2. CABLE CONNECTION2-1. Before connectingBefore connecting your monitor to the PC, change the display screen settings (re
12 2. CABLE CONNECTION2-2. Connecting the signal cable• Be sure that the power switches of both the PC and the monitor are OFF.1. Plug the signal cabl
2. CABLE CONNECTION 13ENGLISH2. Plug the power cord into the power connector on the rear of themonitor and plug the other end of the power cord into a
14 3. ScreenManager3. ScreenManager3-1. How to use the ScreenManagerAs shown on the display, the ScreenManager is used to adjust the LCD monitor.Scree
3. ScreenManager 15ENGLISH3-2. ScreenManager Adjustments and Settings.The following table shows all the ScreenManager’s adjustment and setting menus.“
16 3. ScreenManager3-3. Useful FunctionsAdjustment LockUse the “Adjustment Lock” function to prevent any accidental changes.Locked function • Auto adj
3. ScreenManager 17ENGLISHCP rotinoM DEL)H32~H1(doirePnOnoitarepOneerG"doirepnO"ni.nim51tsaLecitoNecnavdA1*gnihsalFneerGderipxe"doirepn
18 4. ADJUSTMENT4. ADJUSTMENT4-1. Screen Adjustment• Allow the LCD monitor to stabilize for at least 20 minutes before making imageadjustments.Screen
4. ADJUSTMENT 19ENGLISH3. Adjust by using “Screen” menu in the ScreenManager.(1) Vertical bars appear on the screen.ÆÆÆÆÆ Use the “Clock” p.35) adjust
2SAFETY SYMBOLSThis manual uses the safety symbols below. They denote critical information. Pleaseread them carefully. WARNINGFailure to abide by
20 4. ADJUSTMENT(3) The screen position is incorrect.ÆÆÆÆÆ Use the “Position” adjustment.The correct displayed position of LCD monitor is decided beca
4. ADJUSTMENT 21ENGLISH4. To set the Output signal range (Dynamic Range) of the signal.ÆÆÆÆÆ Use the “Range Adjustment”.p.36)This controls the level o
22 4. ADJUSTMENT 4-2. Displaying the low resolutionsThe lower resolutions are enlarged to full screen automatically. Using the “ScreenSize”function i
4. ADJUSTMENT 23ENGLISH2. To be clear-cut the letters or lines of the enlarged screen.ÆÆÆÆÆ Switch the “Smoothing” setting.Select “Smoothing” in the s
24 4. ADJUSTMENT4-3. Color AdjustmentThe “ColorManagement”menu in the ScreenManager enables to change the color of thescreen.Before the Color adjustme
4. ADJUSTMENT 25ENGLISH2. To change the saturation.ÆÆÆÆÆ Use the “Saturation” adjustment.The “Saturation” can be selected from -64 to 64. Setting the
26 4. ADJUSTMENTCP rotinoM DELnOnoitarepOneerGgnivasrewoPgnivasrewoPwolleYedomffOgnivasrewoP1*wolleygnihsalF)hcaerofsemit2(4-4. Power-save Setup• Do y
ENGLISH5. ATTACHING AN ARM STAND 275. ATTACHING AN ARM STANDM4 x 16 mm75 mm75 mmSoft Cloth orCushionThe L461 can be used with an arm stand by removing
28 5. ATTACHING AN ARM STAND3. Attach an arm stand to the L461 securely.For the Portrait display, rotate the monitor clockwise and use the software fo
6. TROUBLESHOOTING 29ENGLISH6. TROUBLESHOOTINGIf a problem persists even after applying the suggested remedies, contact an EIZOdealer. No picture prob
TABLE OF CONTENTS 3ENGLISHTABLE OF CONTENTS PRECAUTIONS ... 41. INTRODUCTIO
30 6. TROUBLESHOOTING Problems Points to check with possible solutions3. Display position isincorrect.4. Screen image is smalle
6. TROUBLESHOOTING 31ENGLISH Problems Points to check with possible solutionsLeaving the screen white may solve the problem.“Sm
32 7. CLEANING7. CLEANINGPeriodic cleaning is recommended to keep the monitor looking new and to prolong itsoperation lifetime.• Never use thinner, be
8. SPECIFICATIONS 33ENGLISH8. SPECIFICATIONSLCD Panel 41 cm (16.0 inch), TFT color LCD Panel with Anti-Glare Hard CoatingViewing Angle: Horizontal:
34 8. SPECIFICATIONSDimensions FRONT SIDE REARDefault SettingsDefault Settings are as follows: ScreenManager menu Default Settings Contr
9. GLOSSARY 35ENGLISH9. GLOSSARYAfterimageThe Afterimage is particular to LCD monitors when the monitor screen is left on fora long period without use
36 9. GLOSSARYPhaseThe phase adjustment decides the sampling timing point for converting the analoginput signal to a digital signal. Adjusting the ph
10. INDEX 37ENGLISH10.INDEXAADJUSTMENT --------------------------- 18Adjustment Lock ------------------------- 16Afterimage --------------------------
38 10. INDEXMEMO
APPENDIX iAPPENDIXAPPENDIX / ANHANG / ANNEXEPreset Timing Chart for Analog inputTiming-Übersichten für Analog EingangSynchronisation des Signaux pour
4 PRECAUTIONS PRECAUTIONS´ If the unit begins to emit smoke, smells like something is burning, ormakes strange noises, disconnect all power connection
ii APPENDIXMode Dot Clock Frequencies A: Front Porch B: Sync PeriodMHzHV HVHVkHz Hz µs/ ms/ µs/ ms/Dot Line Dot LineVGA 0.636/ 0.318/ 3.813/ 0.054/640
APPENDIX iiiAPPENDIXC: Back Porch D: Blanking Period E:Display Period F:Total CycleHV H V H V HVµs/ ms/ µs/ ms/ µs/ ms/ µs/ ms/Dot Line Dot Line Do
iv APPENDIXMEMO
Congratulations!You have just purchased a TCO’99 approved and labelledproduct! Your choice has provided you with a product developedfor professional u
Environmental requirementsFlame retardantsFlame retardants are present in printed circuit boards, cables, wires, casings andhousings. Their purpose is
FCC Declaration of ConformityWe, the Responsible Party EIZO NANAO TECHNOLOGIES INC.5710 Warland Drive, Cypress, CA 90630Phone: 562 431 5011declare th
PRECAUTIONS 5ENGLISH• Keep small objects or liquids away from the unit.Small objects accidentally falling through the ventilation slots into the cabin
6 PRECAUTIONS´ Use the correct voltage.* The unit is designed for use with a specific voltage only. Connection toanother voltage than specified in th
PRECAUTIONS 7ENGLISH´ Handle with care when carrying the unit.Disconnect the power cord and cables when moving the unit. Moving the unitwith the cord
8 PRECAUTIONSSuggestions for Maximizing Comfort´ To lessen the chance of possible injury and to increase your comfort andproductivity while you operat
ENGLISH1. INTRODUCTION 91. INTRODUCTIONThank you very much for choosing an EIZO Color Monitor.1-1. Features• 1280 x 1024 resolution p.36) incorporated
Comentários a estes Manuais